Hydraulic Valve Bodies & Service Parts

This Zinga Filter is from Miller Industries. It is 2.75" OD x 5.18" L and has Buna-N Seals. This filter element SME10 is used in

This cap screws into control valves used by Miller Industries on car carriers. It commonly corrodes from either inside or out. It covers the return to neutral spring mechanism. It is commonly the cause of control lever not moving fully or levers that do not return to their neutral position This part can be used to replace Part Number 9015812.

This 5 Spool Control Valve from Miller Industries is used on the Hydraulics Assembly of many Miller Car Carriers. These include Century, Challenger, Champion, Holmes, and Vulcan Carriers. See the features below for a full list of carriers and see the brochure tab for breakdowns.

Stop hydraulic leaks with this replacement seal kit for Miller Industries Parker Valve Body. Used on most Miller Industries car carriers and conventional wrecker bodies.

Drop In Hydraulic Element Filter. Early style filter used until June of 2007. It is used in filter assembly

Parker VDP11 Series 3-Spool Valve Body. Fits 2010 and older. Has been used in many Miller Industries Small Wrecker Bodies.

This is a replacement filter element for part number 12-0311288 filter assembly and can be used in place of part number 9018309. The filter bypass is in the element. The filtration media in this element is 10 Micron Cellulose with a dirt holding capacity of 11. This element has a 3/4" port size and a 25 PSI bypass. This is the new style filter and will fit the filter assemblies found on Century, Chevron Holmes and Vulcan Wreckers and Car Carriers.

If the four-spool hydraulic control valve on your Miller Industries car carrier is not as responsive as it once was, service it now with a new spool valve repair kit from Parker. The replacement parts will ensure the neutral spring will bring your levels back to center each time. The valve is used on Miller 10 (prior to 2001) and Miller 30 (2005 to present) series car carriers as well as on most twin line Century/Vulcan wreckers.

This is a replacement 2" control lever pressure gauge by Miller Industries. This gauge has a reading up to 5,000 PSI.

Miller dual bonded hose is 180" long and fits on the new style Miller carriers with dual hose trays.

This is a Century oil reservoir, without immersion oil filter, for 10, 12, or 15 series carrier. Mounts on back side of optional toolbox/outside of chassis frame. This part replaces part number 12-0805237.

This is a Miller Industries 1 spool valve body. It is most commonly used on carriers to control an autoload wheel lift.

Fits Century 16 seires generation II car carriers.

This is a replacement hardware kit used with the SafeAll Remote Actuator.

A swing control valve made for Century.

Ominex 12 Function Keypad/ 14 Function Remote